If you do not know how to adjust the garage door tracks, then you have come to the right place.
Garage doors are usually able to open as well as close by means of lifting up and down.
The rollers that are found on the garage door are then given guidance by the two tracks.
The garage door tracks usually run from the ground to the ceiling.
They are also located on either side of the doorway, where you can see an individual door track.
These tracks are designed to help the operation of the garage door become more smooth.
However, when they are hit or when they become loose, the garage door may not be able to operate in the way that you like it.
Moreover if the track has been misaligned, it can cause various issues, such as:
- Binding of the garage door
- Rubbing of the door against the molding
- Creating of a gap between the door and the molding
If you have noticed any of the above mentioned problems as well as the misalignment of the track, then you don’t have to panic.
All you need to do is to call for a garage door repair in Baltimore.
However, if you have the necessary tools as well as experience, here are some of the steps on how to adjust garage door tracks:
Step One: Loosen the Track Screws
Make sure that the garage door is properly secured in the tracks first.
Then, have the screws loosened with the assistance of a screwdriver, which will have the tracks binded in the frame.
Step Two: Adjust the position
By means of a rubber mallet, tap the end of the track and ensure that it is in a vertical position.
To ensure effectiveness, make use of a spirit level to have the perfect alignment of the tracks confirmed.
Step Three: Tighten the screws
Once you have confirmed that the track is now on the correct alignment, just fasten the screws to make sure that the tracks won’t move.
Step Four: Adjust the other track
Once you have had the other track adjusted, you’ll need to move on to the other one.
Just make use of the rubber mallet once again and tap the end of the track.
Make sure that it is aligned straight.
Afterward, fasten the screws.
Using these four steps, you can easily know how to adjust garage door tracks by yourself.
However, keep in mind that if you are not confident, call for a garage door repair in Baltimore immediately.
However, if you have tracks that are rubbing against the rubber molding, or else a gap is noticeable between them, then you can follow the steps below:
Step One: Loose the bolts
The first thing that you need to do is to have the bolts loosened, which secures the tracks to the track bracket by means of a wrench.
Before you move on to the other steps, you have to verify first if the bolts on both tracks have been loosened.
Step Two: Adjust the gap
Simply place one of the tracks left or right until a gap is left of about one-fourth inch, which is between the stop molding as well as the gap.
Keep in mind that the gap should be similar.
Do the same for the other track on the opposite side.
Step Three: Fasten the bolts
Finally, have the track bolts tighten by means of a wrench.
Verify first that they have been tightened well.
However, you must avoid having them overtightened.
Call Smooth Openers.
Not everyone may know how to adjust garage door tracks.
However, you can count on Smooth Openers for that.
For a quality garage door off track repair, Smooth Openers offer only the best service in town.
We offer various garage door services, which include garage door repair in Baltimore and garage door installation in Baltimore.
A garage door off track repair can easily be performed by our professionals, who are licensed and trained in the matters of garage door problems and concerns.
Smooth Openers have been proven and tested, so we guaantee only great services for our clients.
Do not hesitate to give us a call!
When it comes to your garage door, contact us today!